Electro-Voice ZX3-90PI 12-Inch Two-Way Passive Weather-Resistant Loudspeaker System White

Electro-Voice ZX3-90PI 12-Inch Two-Way Passive Weather-Resistant Loudspeaker System White

The Electro-Voice ZX390PI 12-Inch Two-Way Passive Weather-Resistant Loudspeaker System | White is a 2-way P.A. passive loudspeaker with a 600-watt continuous power handling capacity and a 90x50° coverage angle, for wider coverage or shorter distances. The high-tech, high-impact polypropylene enclosure houses a 12" woofer and a 1" Neodymium compression driver with a large 2" voice-coil. The ZX3-90PI cabinet is equipped with 10 integral suspension points for permanent suspension or bracketing, and 3 Anchor Plates for single-stud fittings, with an additional pair of Anchor Plate attachment points on the bottom of the speaker.

This speaker has water-resistant powder coated stainless steel grilles and waterproof glandnut input panels with SJO cable.

Key Features

• DVX3121 12” LF Transducer with Forced Air Cooling
• ND2 2” Voice Coil, 1” Exit Neodymium Compression Driver
• 90 Degrees x 50 Degrees Coverage Pattern
• 600W Continuous (2400W Peak) Power Handling
• High Sensitivity, 131dB Maximum SPL
• Adjustable Monitor Angle (45 degrees or 55 degrees)
• 2 Anchor Plates for Single Stud Fittings and 7 Integral Suspension Points
• Available in Black or White
• Passive/Biamp Selectable
• Full Line of Accessories

Technical Specs

Frequency Response (-3dB)

58Hz – 15kHz

Frequency Range (-10dB)

48Hz – 20kHz

Rec. Hipass Frequency

50Hz

Axial Sensitivity

97dB (1W/1m)

Max. Calculated SPL

131dB

Horizontal Coverage

90 degrees

Vertical Coverage

50 degrees

Power Handling (Passive)

600W Continuous, 2400W Peak

LF Power Handling (Biamp)

500W Continuous, 2000W Peak

HF Power Handling (Biamp)

40W Continuous, 160W Peak

LF Transducer

DVX3121, 12 in (305mm) Driver

HF Transducer

ND2, 1 in (25.4mm) exit Neodymium Compression Driver

Crossover Frequency

2kHz

Nominal Impedance

8Ohms

Minimum Impedance

6.2Ohms

Connectors

Neutrik Speakon NL4's

Enclosure Material

Polypropylene Structural Foam

Suspension

Enclosure has locations for 4 Single-Stud Attachment Plates and 10 Forged Steel Eyebolts – 2 on Top, 2 on Bottom, 2 on Side, and 1 on Rear of Enclosure

Grille

Polyester Powder Coated, 16GA Galvanized Steel, with Rotatable Logo

Dimensions (H x W x D)

613mm x 397mm x 362mm (24.14” x 15.64” x 14.26”)

Net Weight

19.8kg (43.7lbs.)