ORTUR Laser Engraver, Laser Master 2 S2 SF, 5500mW Laser Engraving Cutting Machine, 0.17 * 0.25mm Fixed-Focus Laser Cutter

OLM2PS2-LU2-4-SF-US

• [Product advantage] Ortur Laser 1.8 firmware is optimized the motion algorithm and increases the maximum motion speed from 4000mm/min to 10000mm/mm, the focal point is only 0.17*0.25mm. The optical power reaches 5500mW. So it can cut through 4mm plywood and 11mm pine board at a time. At the same time, the laser cutter comes with an air assist nozzle, use with our air pump could support a higher speed and cut better.
• [Safety protection] Laser Master newly upgraded 5 Safety protection. 1. When the engraving machine is displaced or tilted, it will automatically stop the laser; 2. When the engraving machine or computer crashes, the laser will stop working immediately. 3. The engraving machine is turned on, but there is no movement for a long time, the laser will be turned off automatically. 4. Flame Detector + Buzzer Alarm 6. Emergency stop switch for an emergency.
• [Accessories system update] 1. The laser engraving machine is equipped with the latest OLM-PRO-V10 motherboard, It could preprocess 32 instructions, support baud rate as high as 921600 the engraving accuracy is higher, and the speed is faster. 2. The circuit system with 24V voltage is upgraded, the current is lower, and the system is safer. 3. Update Ortur Laser 1.8 firmware, which is the most advanced laser engraving machine firmware at present. 5. Support Ortur offline control screen.